Operation Methods for WUPRO CINEMA 2023 New Electric Floor Rising Screen
1. Restore Factory Setting
Long press the 'pause' button on the transmitter for 5 seconds → Emitting quick “Beep” sound entering setup mode →Long press the U2 button on the back of the transmitter → A long “Beep” sound emitting → Factory settings successfully restored.
*After resetting to factory settings, the remote control buttons become ineffective. Single tapping the up and down keys on the screen control panel will put it in fine-tuning mode, while long pressing these keys will raise or retract the screen.
*Before re-pairing, you need to turn off the power via the control panel and then restart it.
*The U1 button at the back of the remote control is a non-functional button.
2. Remote Control Code Pairing
Power on and hold the 'up' button on the transmitter for 5 seconds → Emitting slow “Beep” sound entering code learning mode → Release and press 'up' again → A long “Beep” sound emitting → Code pairing succeed.
3. Limit Switch Setting
Click or Press and hole the "Up key" to raise the screen. Since the limit position has not been set, the motor will idle and the screen will slacken when it rises to the highest position. You should immediately press the "Pause key" to prevent the screen from reversing → Press the Up key and the Pause key at the same time once, a long beep will sound, activating the limit position setting mode → After activating the setting mode, the screen is in point motion mode. Adjust the screen to the appropriate highest height by single-pointing the up and down keys, making the screen flat → After adjusting, press the Up key and the Pause key at the same time again, a long beep will sound → The limit position setting succeed.
*The screen's limit position has been preset before leaving the factory.
*The limit position refers to the highest height the screen should reach. If the screen exceeds this limit, the motor will idle, the screen will slacken, and the screen surface cannot be stretched flat.
*Normally, there is no need to change the position of the limit. The limit position only needs to be reset after restoring the factory settings.
4. Upper Limit Position Setting
Adjust the screen to your desired height using the "Up" and "Down" keys on your remote control, then pause → Once the screen is stationary at the desired position, simultaneously press the "Up" and "Pause" keys once to activate setting mode, indicated by a long beep → Simultaneously press the "Up" and "Pause" buttons again, and another long beep emitting → Upper Limit Setting Succeed
*The upper limit position of the screen has been preset before leaving the factory.
*The lower limit position only needs to be reset after restoring the factory settings.
